Khan A-TAC Weaverschiene und Optikmontage

[tuertsch]

Hi all,

hatte noch ein Walther Competition II rumliegen und wollte es auf die Weaver Rail von der Khan A-TAC drauf montieren, aber leider wackelt die Optik auf der oberen und unteren Schiene.
Auf ner RONI zB sitzt es genau richtig...
Das sollte ja schon auf ner Rail der Khan auch drauf passen, oder?

danke!

[Al3x]

Weaver (dein Walther) auf Picatinny (die Rail der A-TAC)...hast in dem Fall Pech.

http://www.brownells.com/.aspx/lid=1072 ... ifference_

Besser verständlich:

Compatibility with Picatinny

Military standard, MIL-STD-1913 "Picatinny rails" date from the mid-1990s and have very strict dimension and tolerance standards. The Picatinny has rail of very similar profile to the Weaver, but the slot width is 0.206 in (5.23 mm), and by contrast with the Weaver, the spacing of slot centers is consistent, at 0.394 in (10.01 mm). Many rail-grabber-mounted accessories can be used on either type of rail, and generally accessories designed for a Weaver system will generally fit Picatinny rails - although not vice versa. The Picatinny locking slot width is 0.206 in (5.232 mm) and the spacing of slot centers is 0.394 in (10.008 mm).Because of this, with devices that use only one locking slot, Weaver devices will fit on Picatinny rails, but Picatinny devices will not always fit on Weaver rails.

The other difference is that Weaver rails are continuous, while Picatinny rails are cut by the slots (like a dotted line) to neutralize expansion caused by barrel heating.

Du brauchst was mit 2 Schrauben, aber das 30 Euro Walther wirds dir ohnehin von der 12/76 runterfetzen....bleib bei den Irons.

[tuertsch]

danke dir!

schade, irgendwie wärs schon spassig was auf der Rail zu haben, werd mal schauen was es so günstiges gibt für die Khan